MGB Compressor Mount

MGB compressor bracket for Sanden 505 compressor.  This bracket will fit every MGB engine made, it is designed to work with Generator and alternator blocks.  The bracket mounts on passenger side of the engine using the stock holes on the block and front timing plate. The bracket requires the use of the stock pulleys for the compressor with the assistance of an idler pulley.  The atlernator uses the compressor for belt tension. 

The bracket comes complete with all necessary hardware to mount a 505 compressor:

• Bracket with alternator tensioner
• Idler pulley and ecentric
• Two belts
• All necessary bolts, washers, and nuts
• Directions.

This bracket is manufactured in the USA by Nostalgic Air Parts.

This bracket will not work with superchargers.  If you setup requires a smog pump the bracket will require minor fabrication.